Dell Inspiron 1720 Series
Notebook Hard Drive Installation Guide
Before
you begin any of the procedures in this section, follow these
steps:
1.
Shut down the computer. If you are unsure
whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating
system.
2. Disconnect
all external devices connected to
the computer.
3.
Disconnect the power from the computer by first
unplugging the power cord from the AC outlet and
then unplugging the AC adapter from the computer.
4. Remove the battery
5. Turn the computer
over
6. Loosen
the two captive screws that secure the hard drive cover, then remove
the cover and set it aside.
NOTICE: Use firm and even pressure to slide the hard
drive into place. Excessive force may result in damage to the connector.
NOTICE:
If only one hard drive is installed, or is being
installed, ensure that the drive is installed in the primary hard drive
bay. Install an optional second hard drive in the secondary hard drive
bay.
7a. To remove the origianl hard drive, using the pull tab on
the hard drive, pull the hard drive out of the hard drive bay.
7b. To
install new hard drive, place the hard drive into the appropriate hard
drive bay, and then press down to fully seat it in its connector.
8. Replace
the three M2.5 x 5-mm screws to secure the hard drive.
9. Replace
the hard drive cover, and then tighten the screws.
10 Install
the operating system for your computer, as needed
11. Install
the drivers and utilities for your computer, as needed (see
"Reinstalling Drivers and Utilities" in your
Owner's Manual).
